Rough In	Connections	Computer/Transformer

Introduction		Heatizon Systems Installation Introduction
Roughing In
	1	The Backing Plate
	2	Backing Plate Location and Rough-in Box
	3	Mounting the Backing Plate
	4	Determining the Connection Points
	5	Running the Cold Leads
	6	Jumpers Between Areas
	7	Locating the Activation Device
	8	Running Primary Power

Connections
	Cold Lead to Cold Lead	1	Crimping the Connection
		2	Soldering and Heatsink
	Cold Leads to Tuff Cable	1	Crimping the Connection
		2	Soldering and Heatsink
	Tuff Cable To Tuff Cable	1	Tuff Cable Splice
	Tuff Cable to Zmesh	1	Cold Lead to Transition Plate
		2	Zmesh to Transition Plate
	Zmesh to Zmesh	1	Positioning the Splice Plate
		2	Soldering the Splice Plate

Computer Controls & Transformer
	1	Introduction & Mounting the Transformer
	2	Sheet Metal & Control Box Mounting
	3	Cold Lead Connections and the Torroid
	4	S202 & S203 Dual Output Transformers
	5	Transformer Primary Connections
	6	Primary Power to the Computer Controls
	7	The Thermostat Wire
	8	The Thermistor
	9	Placing the Computer Jumpers
	10	Inserting the Control Board
	11	Preliminary Amperage Testing
	12	Adjusting the Potentiometer
	13	Final Adjustments and Warmup
	14	Testing and Recording System Information
	25	Activation Device

* BACK *

© Copyright 2005-2008 Comfort Radiant Heating, LLC. All Rights Reserved.
Comfort Radiant is an authorized Heatizon distributor.